Alpes Lasers . TC-3 Uživatelský manuál stáhnout pdf (Strana 37)

TC-3 Temperature Controller User’s Manual · Page 37

Error Messages

Error

Code

Description Cause

E-

100

General Error The error code is non-specific, and is

generally used when no other error

code is suitable.

E-

102

Message too long The message is too long to process

(USB/Serial only).

E-

104

Type not allowed The RADix type was invalid

E-

123

Path not found The message used an invalid path

command (USB/Serial only).

E-

124

Data mismatch The message contained data that did

not match the expected format

(USB/Serial only).

E-

126

Too few or too

many elements

The command requires more or less

than the number of parameters

actually supplied.

E-

127

Change not

allowed

An attempt was made to change a

parameter that cannot be changed, or

is currently read-only.

E-

201

Data out of range The message attempted to set a value

that was outside the allowable range

(USB/Serial only).

E-

202

Invalid data type When trying to parse the message, the

data was in an invalid format

(USB/Serial only).

E-

204

Suffix not valid An invalid number base suffix (radix)

was encountered when parsing a

number (USB/Serial only).

E-

402

Sensor open,

output turned off

A sensor open circuit was detected and

the output was turned off.

E-

403

Module open,

output turned off

A Peltier module open circuit was

detected and the output was turned

off.

E-

404

I limit, output

turned off

A current limit was detected and the

output was turned off.

E-

405

V limit, output

turned off

A voltage limit was detected and the

output was turned off.

E-

406

Thermistor

resistance limit,

output turned off

The thermistor resistance limit (high or

low) was exceeded and the output was

turned off.

E-

407

Temperature limit,

output turned off

The temperature limit (high or low)

was exceeded and the output was

turned off.

1 2 ... 32 33 34 35 36 37 38 39 40 41

Komentáře k této Příručce

Žádné komentáře

Alpes Lasers . TC-3 Uživatelský manuál Strana 37

Komentáře k této Příručce